Installation method of composite panel tile press
Composite panel tile press installation in strips or blocks The strip or block installation method refers to dividing the network frame into strips or block units, which are hoisted by lifting equipment to the high-altitude design position and placed in place, and then integrated into a whole. installation method.
Strip means that it is divided into several sections along the long-span direction of the grid. The width of each section can be from one grid to three grids, and its length is the span of the short span of the grid. Block shape means that the unit shape after dividing along the vertical and horizontal directions of the network frame is rectangular or square. The weight of each unit of the composite panel tile press is subject to the lifting capacity of the existing lifting equipment on site.
Composite panel tile press installs in strips or blocks. Most of the welding and splicing work is carried out on the ground, which is conducive to improving the quality of the project and can save most of the assembly brackets. Since the capacity of the existing lifting equipment on site has been considered when dividing the order, the existing equipment on the site can be fully utilized, and the rental fee for the lifting equipment can be reduced. The high-altitude bulk method of the composite plate machine refers to the combination of small units or parts A method of assembling directly at the design position (single member and single node).
Composite plate tile press high-altitude bulk method has two kinds of full support (that is, full scaffolding) method and cantilever method. The full bracket method is mostly used for assembly of parts, while the cantilever method is mostly used for the assembly of small units at high altitudes. Since the parts are assembled at a high altitude, there is no need to use large-scale lifting equipment, but due to the large-scale assembly support, a large amount of scaffolding materials are required.
Post time: Aug-08-2023